Glass Midlew Repair

01

01.

The above figure indicates a moderate glass molding condition, in this case, a small part of the moldy area was sealed with tape in order to observe the contrast effect after the repair in the later stage.

02

02.

Use a mold removal agent and sponge in the operation of mold removal from the molding area, please note that during the operation the operator must wear rubber gloves, and the operation time can not be greater than 3 minutes.

03

03.

Repeatedly wipe the molding area with a sponge and mold remover, during the operation, please ensure a safety handling and avoid contact with the skin.

04

04.

The above figure shows the effect after wiping and cleaning, it can be seen that the molding area has improved, but the bad condition is still very obvious.

05

05.

Use the speed-adjustable Angle Grinder and Polishing Pad to polish the molding area.

06

06.

During the polishing process, add water continuously to ensure smooth and orderly rotation during operation. it cannot be polished in the condition where the mould-removal agent is still present!

07

07.

After polishing, it can be seen that after the completion of the mold removal and polishing process, the glass is clean and new, and there is a clear contrast between this and the untreated area.

Other Cases

Online WeChat +86-22-88230488 top